How to reprogram Flow remote gdrc-86xt, Synergy V RT-U64CD-35F, Motorola DRC800, Gdi gdrc-86x

Gdrc-86xt

If you have a remote and it is not working there are a number of reasons that can cause this.

1. If you are pressing buttons and the blue led (light) on top of it is not blinking when you press a button the battery is dead or not making proper contact. You may be lucky and just have to spin the battery a couple times to get the remote to work. If not you will have to replace the battery.

2. The remote may has lost its programming, due to dead batteries or on its own. To reprogram it:
Press the Green CBL button
Press and Hold(4 seconds) the Red POWER and Blue MUTE buttons until the blue led stays on
Press 001
Press the Blue MUTE button
The cable box should now work
NOTE: You can also program the remote to control your TV. The details for this is in full manual below.

3. The remote is faulty. Flow will replace a faulty remote for free at any of their main offices.

The full manual for Gdrc-86xt (pictured at top) can be found here:https://www.scribd.com/doc/147435246/Manual-de-Usuario-Control-Remoto-Intercable-GDI-GDRC-86XT

Synergy V RT-U64CD-35F

The manual for the bigger colourful remote, Synergy V RT-U64CD-35F (pictured above), can be found here http://help.rcn.com/pf/12/webfiles/files/ONNET6907/remotes/RC-U63CDR/RC-U63CDR.pdf
In the manual you will find all the codes for programming this universal remote and instructions on using it.

The manual for another large black/grey with blue button (no picture shown) RT-U50 remote is here http://help.rcn.com/pf/12/webfiles/files/ONNET6907/remotes/RT-U50-redesign/index.htm

1. Press [OK / SEL], then [MUTE] together - hold both buttons down until the mode (power) buttons start blinking in sequence
2. Enter the three digit code 001 or 002 or 003. 
3. Press [MUTE]. If your CABLE converter (box) turns back on, press [OK / SEL] to lock in the code. The mode (power) buttons will blink 3 times and go out.
4. If your CABLE converter (box) does not turn back on, repeat steps 2 and 3 with a different code until you can turn your CABLE converter (box) off and on.

Motorola DRC800

The manual for the other big remote, Motorola DRC800 4-in-1 Universal Remote Control (pictured above) is found here:
http://www.manualslib.com/manual/107028/Motorola-Drc800.html

GDI gdrc-86x

Analog Flow cable boxes use the GDI Gdrc-86x. This does not have codes to be programmed as it is a single purpose remote. If it is not working, the batteries are bad or the remote itself is bad.


Flow's website: https://discoverflow.co/trinidad/ for office locations and contact numbers. Take the remote in to their office and they replace it for free.

Disclaimer: I am in no way associated with Flow, I am just trying to be helpful.

Please click an ad to support this blog if this was helpful.
Updated January 24th 2017.

Topics: How to set up Flow Trinidad and Tobago cable tv remote
Instructions to configure Flow cable tv remote
Cable box lost settings to change channels
How to make cable remote control television also
How to fix Flow remote
Directions to reset Flow remote
How to programme Flow Remote